Plastics pipes and fittings. Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusionBS ISO 11414: 2009 Plastics pipes and fittings. Preparation of polyethylene (PE) pipe pipe or pipe fitting test piece assemblies by butt fusion BS ISO 11414 specifies a method for preparing butt fusion jointed test piece assemblies between polyethylene (PE) pipes and spigot ended fittings. BS ISO 11414 also specifies the assembly parameters involved, such as the ambient temperature, joint geometry and fusion parameters, taking into account the service

Deviation from the base standard

BS EN ISO 9445-2:2010 Continuously cold-rolled stainless steel

ISO 9003:1994

delivering and managing BCM within an organization (the BCM manager)

welding personnel

both during and after installation and which can accept slight offset of the centre line

BS EN 62135-2 takes precedence over all aspects of the generic standards and no additional EMC tests are required or necessary

4 Supplier framework

Managing website standards: Supporting editors

This standard includes the following cross references:

Interoperability matrices

Welding processes that are not under direct manual control are subject to comprehensive test and acceptance specifications