1.2 & 1.4 TSI High Flow Carbon Intake (138 & 150 BHP)This product is ideally fitted in conjunction with the product FMDV1 (1. 2 1. 4 TSI Dump valve and fitting kit). If purchased as a stand alone product the turbo inlet hose will push up against the adjacent OE charge pipe, and a trim to the turbo inlet leg of the FMINDK14 induction hose may be required to avoid creasing. Highlights Part of the Forge Motorsport Hi Flow range Increases air flow and improves efficiency and performance Up to 10 BHP gain

Width across smallest diameter is 120mm

it has been created to capture the maximum amount of harmful contaminants

It also allows for rod adjustment to suit the customers individual application

Inside diameter: 54mm (2 1/8")

Elbow angle: 90 Degree

the peaks are at 5mm

This means once the top mount has been fitted the spring should be secured into place by winding the twin locking collars up

Click here to find out about information and care for your

1 x 6mm-4mm Plastic Reducer

due to its revised design

28mm 90° Elbow Silicone Hose

0 bar) - spool up/running pressure 9 psi (0