Snap head steel rivets for aircraft

to decide upon the acceptability of the specimens

Part 7 of BS EN ISO 14644 specifies the minimum requirements for the design

Why should you use BS 5431 - specification for bending springs for copper tubes

The requirements of this part are complementary to the common requirements formulated in BS EN 474-1:2006+A1:2009

are covered by IEC 60146-1-1

used to carry high-frequency electrical signals with low losses

The standard has been updated to take account of the Construction (Design and Management) Regulations 2015 (CDM)

it is not necessary to repeat the test

ships and aircraft

to a representative measure of accuracy

BS EN ISO 11737-1 is the standard for sterilization of medical devices

BS 6137 specifies no requirements for the condition