Paints and varnishes. Determination of stone-chip resistance of coatings - Single-impact test with a free-flying impact body1 Scope This part of ISO 20567 specifies a method for the evaluation of the resistance of automobile finishes and other coatings to the impact of a single, free flying body projected onto the surface under test to simulate the impact of stones.

Annex ZA (informative) Clauses of this European Standard addressing essential requirements or other provisions of EU Directives

Conformity assessment - Supplier’s declaration of conformity - Part 1: General requirements

where specifically stated

Reference is made in this document to laser “users”

The conformity of production is the responsibility of the tubing manufacturer

The third category of measurements includes those to be carried out on a complete modulator/demodulator (modem) assembly except that the actual or system demodulator is replaced by a measurement demodulator

Manufacturers of plastic / thermoplastic products

NOTE 2 For craft

compaction methods

BS EN 15101 gives specification for the loose-fill cellulose insulation (LFCI) products that helps the user in the installation of the specimens

the procedure is not recommended for conjugated linoleic acid (CLA)

ISO 787-14 provides you with the test to determine the electric resistivity (specific electric resistance) or the specific electric conductivity