Rear Accessory Plate for Ultra 10The Rear Accessory Plate allows you to take advantage of the real estate behind the Ultra 10 by adding mounting points for accessories: wireless receivers like Bolt, Light Rangers VIU, BitBoxes, and more. This slim, lightweight aluminum plate includes blind holes to prevent damage to the monitor. Anti twist pinholes are through holes to capture a variety of accessories without the pinholes bottoming out.

Eight mounting screws are included in the package

you will need a Canon EU-V1

The D-Tap 2pin to Power Cable has a standard D-Tap on one end and a 0B

Low power consumption allows you to run without excessive swapping

Insert the dummy battery end into your camera and connect it up to the FOCUS monitor's output for power

allowing Run/Stop to the 3-pin connector port via the camera's Remote port when attached to the Remote-In port on the B-Box

This mat includes a light magnetic strip at the top to hold small screws and tools when making adjustments to your build or project

The new EVF System opens up the positioning of the EVF to different locations

5-inch display with sharp resolution and fantastic color & contrast for accurate image control

The TX Kit includes

The included Allen wrenches and screw make it easy to install this friction-based pan axis on your SmallHD Tilt Arm

2 pin LEMO compatible connector on the other