Panhard Bar Slider 1" x 7/16" Rod EndHyper Racing # 04 160 HBS design. Fits 1" Frame member and 7 16" Rod End. This is the one Hyper chassis use for the front panhard bar clamp. Hardware: (1) 7 16 20 x 2 HHCS with (1) 7 16 20 nylock half nut (1) 1 4 28 x 2 HHCS with (1) 1 4 28 nylock full nut (1) 1 4" AN washer (1) 7 16" AN washer In order to meet the Sharp Mini Late Model rules, you will need to replace the 7 16 20 x 2" HHCS with a 7 16 20 x 2 " bolt. Our part numkber 971 07 20 2. 25.

Hyper Racing # 03-165

Hyper Racing # 02-180

Powder coated black

5" distance from center of hole to center of hole

Hyper Racing # 03-1375

Hyper Racing # 04-504

00" diameter 7075 T-6 USA snout

Hyper Racing # 02-330

Hyper Racing # 02-125

with a 1-1/8" dia

Hyper Racing # 01-120

You will also need an offset right rear