End mills and slot drills - Dimensions and designation of milling cutters with Morse taper shanks1 Scope This part of ISO 1641 specifies the general dimensions and designation of the following milling cutters with Morse taper and having a tapped hole: end mills, flat ended or ball nosed standard series and long series; slot drills short series and standard series. Morse taper shanks are in accordance with ISO 296 and ISO 5413. It is not applicable to the end mills and slot drills with cylindrical shank, which are dealt with in ISO 1641 1; it is

This part of ISO 8835 also specifies requirements for transfer and receiving systems of active anaesthetic gas scavenging systems in which the power device is integral with the transfer and receiving system

The determination of dynamic mechanical properties is a technique that is widely used to characterize material properties as a function of temperature

and a standard substrate

It is applicable to documents containing combinations of character

Minimum rope resistant factors

All OACS compliant amplifiers support the full set of “universal” OACS commands

it requires less manpower

steam boilers and hot water generators are vessels and pipework systems in which:

Short-circuit voltage

Guidance is given on the methodology and formulae required in ensuring that the appropriate systems are activated in an appropriate manner and within given criteria

This standard complements BS 9999 Code of practice for fire safety in the design

NOTE 2 The titles of the publications referred to in this standard are Iisted on the inside back cover