C170M-19X27 Locking AssemblySingle taper, self centering design with mounting flange for use in through bored components with smaller pitch outside diameters. Mounted component remains fixed axially during installation. View Catalog PageInstallation & Removal Instructions

High axial load and torque capacity and does not mar the shaft

Mounted component moves axially during installation

Design fully engages the thread for secure locking

Recessed screw head provides safety with an outside surface free of major projections

Self-lubricating bearings resist corrosions

Provides greater axial holding power than set screw or one-piece clamping collars

View Catalog PageInstallation & Removal Instructions

Ideal for space constrained areas

Effective on both hard and soft shafts

self-centering design without mounting flange for use in through-bored components

Acetal Copolymer collars will not rust or corrode

Bearing insert is encased in non-conductive