GH1C-212-SS 2-1/8" ID Stainless Steel One Piece Clamping Shaft CollarDesign fully engages the shaft without marring. Recessed screw head provides safety with an outside surface free of major projections. Provides greater axial holding power than set screw collars. Effective on both hard and soft shafts. View Catalog Page

View Catalog Page

Bronze Bearing Type

Effective on both hard and soft shafts

oil resistant rubber liner which corrects up to 2° misalignment while reducing vibration & noise

Porous flanged bronze bearing is press-fit in sturdy zinc die cast sphere with felt strip for lubrication

Design fully engages the thread for secure locking

Traditional cost effective rigid coupling design

Can be mounted vertically or horizontally

Spring-lid oil cap can be positioned 4 ways

Two-Piece Housing has rust-proof plated finish

Ball Bearing Type

Easily installed where major disassembly would otherwise be required