End mill holder Weldon SK 40 - 14 - 160Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

The collet clamping Ø range is always up to 0

- 100µ stainless steel mesh filter

E2= 10 pieces

The internal thread provided in the PSK tool holder for

For the coolant supply through the centre of HSK toolholders

bei Ø 6 – Ø 32 mm = h236

bores and other details

Through hole for internal cooling provided

For machining centres with synchronous spindle

For right-hand and left-hand threads

Angle reading and adjustment using a vernier

Made of precision ground hardened stainless steel