ER-Collet with cooling channels ER16 | 426ECC | < 15µm | Ø 5Application: For mounting straight shank tools in collet chucks DIN 6499. Note: Only nominal size d can be clamped, with cooling channels. In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet. (applicable up to 21 bar)

Ergonomic Handle of Design

E3= 12 pieces

5V AA Batteries * 3 ( Do not use low self-discharge battery )

with adjustable ball spray nozzles

With clamping screw and O-ring

Ratchet stop

The insert is clicked into our grid system with

bei Ø 6 – Ø 32 mm = h235

PSK = PSK 63

For use on vises

chip breaking

lockable in different positions