Cutter arbors with tenon drive - Dimensions of hollow taper interface with flange contact surface1 Scope This part of ISO 3937 specifies the dimensions of cutter arbors with tenon drive and with hollow taper interface with flange contact surface (HSK). It also specifies the dimensions of cutter arbors with tenon drive and enlarged contact surface of the cutters. The interchangeability dimensions of the milling cutter bearing on the cutter arbor are in conformity with ISO 2780. The dimensions of the retaining screw used are specified in ISO 2780.

BS EN 13068-2 gives guidance on the on-site check of equipment for radioscopy where the image is presented on a display unit including image processing

It applies to devices designed for continuous (fixed or adjustable) flow and/or for bolus application

BS EN 60068-2-53:2010 Environmental testing

locating and installing new passenger and passenger/goods lifts

incorporating corrigendum January 2013

procedures and ancillary equipment

tensile modulus and other aspects of the tensile stress/strain relationship under the conditions defined

Together with the requirements and acceptance conditions for the raw materials determined in EN 13121-1

41NiCrMo7-3-2) have been deleted

for all power frequencies including d

Fire alarm warnings for people with impaired hearing

and envelope dimensions of various connector configurations