Micrographics. Quality control of COM recorders that generate images using a single internal display system - Method of use

The test in BS EN 60512-23-7 is based on the line injection test method according to IEC 61196-1 with a specific type of injection wire

BS EN 12312-18 also takes into account some performance requirements recognized as essential by authorities

Corrosion resisting plain spherical bearings are built to handle strong radial forces while maintaining constant effectiveness of their quality

is dependent on carrying out an effective risk assessment that identifies the hazard to be faced

Conformity to specified requirements

This British Standard specifies requirements for the testing of substrates (the growing medium) for constructed green roofs intended to provide long term support for specified plant communities

— access gangways (including side ladders)

BS 8544 gives guidance and recommendations on undertaking LCC of maintenance during the in-use phases of facilities or constructed assets

irrespective of the sector involved

BS 7121-12:1999 gives recommendations for the care and safe use of recovery vehicles and equipment

as well as the rules for the representation of seismic actions

This British Standard specifies the materials used in the manufacture of component parts of surgical elastic band trusses